Seat comfort
The seats are high, providing increased comfort for adults in the paddling position.
The seats are to be placed according to the number of persons on board, just behind the markings printed on the floor.
On the "2" markings (which therefore remain visible) when there are 2 persons on board. On the "1" marking when there is only 1 person on board.
Ensure that you balance your load to optimize kayak performance.
Technical dimensions and weights.
INFLATED SIZE
Length: 340 cm
Width: 103 cm
FOLDED & BAGGED SIZE
Height: 67 cm
Width: 44 cm
Thickness: 30 cm
Weight: 14 kg
Maximum pressure: 0.1 bar (1.5 PSI)
Seats: 1 or 2 seats
Content: kayak, bag, repair kit, skeg
PADDLE NOT INCLUDED
PUMP NOT INCLUDED
For use with an Itiwit double-action hand pump with adapters
After-sales service
Spare parts are available for Itiwit kayaks from after-sales service. Visit the workshop at your nearest Decathlon store to collect or order some.
Inflation recommendations & precautions
Inflate the floor, then a side tube, then the second one to 50%. Check the positioning of the chambers. Then fully inflate it to a maximum pressure of 0.1 bar (1.5 psi).
DO NOT OVER INFLATE!
Ensure the valves are properly closed.
Install the 3 skegs, unless using on a river with a low water level.
In the event of EXTREME HEAT, slightly deflate the kayak out of the water to avoid over-inflation, which could damage the kayak.
Do not leave inflated in direct sunlight: risk of over-inflation
Care instructions
In the event of damage to one of the side chambers, open the side tube lengthways using the zip and remove the chamber.
The floor can be uncovered by opening the rip-tab fastenings.
Example 1: the hole is in the side tube; you can use the repair kit to stick on a patch.
Example 2: The hole is located along a seam; contact the DECATHLON workshop service to exchange the faulty bladder (2-year warranty).
Glide performance
Patented bow shape: The front and back ends provide good glide. The V-shaped front of the kayak enables smooth entry into the water.
Easy to disassemble and fold
New carry bag, backpack style for short distances.
Easy-clip fins.
Deflate the kayak by opening the 3 "Boston" valves.
Fold the lateral tubes down onto the floor.
Roll, starting from the opposite side to the valves to remove the air.
Place the rolled-up kayak into the main compartment of the bag.
Close the zip and tighten using the compression strap.
Directions for use.
We recommend that you use the product with a buoyancy vest.
regulations for canoes/kayaks measuring less than 3.50 metres
Is your canoe-kayak inflatable or rigid and is less than 3.50 metres? You have what is called a beach craft.
You must always stay within 300 metres of a shelter (any place on the coast where any craft or vessel and its crew can get to safety by anchoring or berthing, and set off again without assistance).
Buoyancy life vests are not mandatory but strongly recommended to make it easier to get back in the boat if you fall out.
More than 3.50 metre canoe-kayak rules
Your canoe/kayak is rigid or inflatable with at least 2 separate air chambers. It measures more than 3.50 metres. It is approved for sea use by the manufacturer.
You can paddle up to 2 nautical miles (approx. 3 km) from shore. You must carry a number of items of safety equipment.
You can find a list of these items via this link: https://www.itiwit.fr/reglementation-pour-faire-du-canoe-kayak
