| Technical dimensions |
Max. usage size: 205 cm
Min. usage size: 165 cm
Disassembled size: 85.5 cm
Weight: 850 g
Tube diameter: 30 cm
Blade surface: 510 cm² (79 inch²) |
| How to dismantle your paddle |
To disassemble the paddle, press the push pin on the back of the tube and pull on the parts to remove them.
Disassembling the paddle allows it to be kept in the SUP bag, or put in a car boot.
The dismantled paddle measures 85.5 cm. |
| How to adjust your paddle |
To adjust the paddle, open the latch, pull the handle to the desired length, then close the latch. The alignment rail ensures that the handle is properly in line with the blade.
If it is not fastened tightly enough, open the latch and tighten the metal screw.
The paddle can be adjusted to about 10-15 cm above your waist: remember feeling comfortable is the priority |
| How do you care for your paddle? |
After a stand up paddleboarding session, it is important to rinse your paddle with clean water.
To avoid salt crystals building up on the tightening bolt and inner tubes, rinse the paddle in warm water. This will extend the life of your paddle.
In the event of breakage or loss, the blade (8817696) is available in our after-sales service section |
| What should I do if my paddle slips too much? |
For better grip on the shaft, apply a little wax to the handle. |
| Recommendations for use |
The paddle is your means of travel and therefore of returning safely.
Never leave your paddle floating in the water or you risk losing it.
If you take a break, leave the paddle on the board, attached to the elastics. |
